Mediclinics M04A Manual De Instalación Y Utilizacion página 11

INSTALLATION
Dismantling for installation
The removal of the cover of the dryer must be carried out by releasing the
cover fastening clips located on top of the said cover. In order to do this,
please displace the cover downwards in the horizontal plane and then
extract it vertically.
Whilst carrying out that process, please avoid:
• Damaging the internal components, especially the IR sensors of the
electronic circuit.
• Scratching the cover and the IR sensors screen.
Mounting
It is suggested that the electrical installation of
the appliance is carried out through the rear canalization.
• The terminal strip where the electrical supply cables
will be accommodated as well as their access hole
(Ø22 mm – Ø 0.87 "–) are put up in the right hand
side of the dryer.
• This dryer is a class II appliance and does not
require grounding.
• The installation process can be summarized as follows:
1. Make the 4 Ø6 mm (Ø 0.24") drill holes with
the help of the template provided. Clean the holes
of the resulting dust. Introduce the 4 wall plugs
provided until they are at wall's level.
2. Pass the electric cables that come from the wall
through the access hole (Ø22 mm – Ø 0.87 "–).
-11-
www.mediclinics.com