Automatic Power­off Function; Led Light; Setting The Tool To Con- Figuration Mode - Panasonic EYFPA1C Manual De Instrucciones

Automatic power­off function
EN EN
The automatic power-off function is designed
to prevent a loss of tightening torque due
to reduced battery voltage. Once it has
been activated, the tool will not operate until
the battery pack has been charged (or re-
placed with a fresh unit), even if the trigger is
depressed.
NOTE:
• All 3 bars on the battery indication lamp
will flash when the automatic power-off
function is activated.
• When the battery indication lamp begins
flashing, the battery pack should be
charged (or replaced with a fresh unit)
immediately.
• Be sure to fully charge the battery pack
in question after activation of the auto-
matic power-off function. Failure to do
so may prevent the automatic power-off
function from being properly deactivated.

(3) LED light

This function is limited to "Linked to LED light
button."
[Fig.14]
Pressing the
on and off.
The light illuminates with very low current, and
it does not adversely affect the performance of
the tool during use or its battery capacity.
CAUTION:
• The built-in LED light is designed to illu-
minate the small work area temporarily.
• Do not use it as a substitute for a regu-
lar flashlight, since it does not have
enough brightness.
Caution : DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure.
Setting the tool to con-
figuration mode
1. Turn off the control panel.
If the control panel is on, remove and then
reinsert the battery pack.
button toggles the LED light
. Depress the switch while pushing the
button and then release both the
ton and the switch.
After all the LED lamps have turned off,
the control panel will flash and change to
configuration mode.
[Fig.15]
NOTE:
• Tools ship from the factory set to "F"
mode (torque control function off).
• The control panel will turn off if the tool
is not operated for a period of 5 min-
utes.
Configuring the torque clutch
setting
[Fig.16]
1. Press the
clutch setting that is appropriate for the
work being performed.
As the button
is pressed
29 30
28
• "F" indicates that the torque control func-
tion is off.
• You can select from 30 torque clutch
settings (1 to 30).
• Use figures from the Tightening Torque
Chart to guide your selection of torque
clutch setting. (See the following tighten-
ing torque chart)
. Press the OK button to accept the select-
ed torque clutch setting.
The control panel will stop flashing and
light up.
CAUTION:
• You must press the OK button in order
for the selected setting to take effect.
• Be sure to verify the new value after
changing the setting.
- 14 -
and buttons to select the
As the button
is pressed
F 1 2
... 3
but-