System Description; Delivery Check - Sundstrom SR570 Instrucciones De Uso

1. General information
2. Parts
3. Use
4. Maintenance
5. Technical specifications
6. Key to symbols
7. Approval
1. General information
Use of a respirator must be part of a respiratory protec tion pro-
gram. For advice see EN 529:2005 or AS/NZS 1715:2009. The
guidance contained in these standards highlights important
aspects of a respiratory protective device program but does
not replace national or local regulations.
If you feel uncertain about the selection and care of the
equipment, consult your work supervisor or get in touch with
the sales outlet. You are also welcome to get in touch with
the Technical Service Department at Sundstrom Safety AB.

1.1 System description

SR 570 together with the fan unit SR 500/SR 700 and approved
filters is included in the Sundstrom fan-assisted respiratory
protective device system conforming to EN 12941:1998 and the
Powered Air Purifying Respirator (PAPR) system conforming
to AS/NZS 1716:2012 (Fig. 1). The breathing hose must be
connected to the fan unit equipped with filters. The above-
atmospheric pressure generated in the head-top prevents
particles and other pollutants from being admitted into the
breathing zone.
SR 570 can also be used together with compressed air attach-
ment SR 507 conforming to EN 14594:2005 (Fig. 2).
1.2 Applications
The equipments can be used as an alternative to filter respira-
tors in all situations in which these are recommended. This
applies particularly if the work is physically demanding, warm
or of long duration. When selecting the head-top, some of
the factors that should be taken into account are as follows:
• Types of pollutants
• Concentrations
• Work intensity
• Protection requirements in addition to respiratory protective
device.
The visor provides protection for the eyes and the face from
various hazards such as flying objects, impact, splashes and
airborne debris.
The bump cap provides head protection that protect the user
when colliding with stationary objects.
The risk analysis should be carried by a person who has
suitable training and experience in the area.
1.3 Warnings/limitations
Note that there can be national differences in the regulations
for use of respiratory protective equipment.
Do not use the equipment in environments:
• that are Immediately Dangerous to Life and Health (IDLH),
• where the ambient air is oxygen-enriched air or does not
have a normal oxygen content.
• where the pollutants are unknown.
Face shield SR 570
Do not use the equipment:
• If the fan is not running. In this abnormal situation, the
equipment will provide no protection. In addition, there is
risk of carbon dioxide quickly accumulating in the head top,
which would lead to oxygen deficiency.
• without the face seal of the head-top against the face is
assured. The face seal must firmly come in contact with the
face to form the pressure that is necessary for establish the
correct protection factor. This may be difficult to achieve if
the user has a beard or sideburns.
Materials that come into contact with the skin of sensitive
people may cause allergic reactions.
Damaged or scratched visors must immediately be replaced.
Eye-protectors against high-speed particles worn over stan-
dard ophthalmic spectacles may transmit impacts, thus
creating a hazard to the user.
Where the markings on the visor and visor frame are different,
the lowest applies.
The eye protection according to EN 166:2001 is valid at
temperature -5 °C to +55 °C.
Be aware that the breathing hose might make a loop and get
caught up by something in your surrounding.
Stop the work immediately:
• if you find that breathing is difficult,
• if you experience dizziness, nausea, or any other noticeable
physical effect.
• if you smell or taste the pollutants.
Note that the equipment:
• not is approved for use in an explosive atmosphere.
• if the user is exposed to very high work intensity, negative
pressure may occur in the device during the inhalation
phase, which may involve the risk of leakage into the
head-top.
• may reduce the protection factor if it is used in surroundings
in which high wind speeds occur.
• should never be lifted or carried in the breathing hose.
• if protection against high speed particles at extremes
of temperature is required, the letter T must be written
immediately after the impact letter, i.e. BT. If not, the eye-
protector shall only be used against high speed particles at
room temperature.
2. Parts

2.1 Delivery check

Check that the equipment is complete in accordance with the
packing list, and undamaged.
Packing list
Fig. 3
1. Face shield
2. Breathing hose
3. Peel off with clips
4. User instructions
5. Cleaning tissue
EN
21