Section 2. General Description; Introduction; Description; Section 3. Installation Information - Zodiac Jandy Pro VS FloPro Serie Manual Del Usuario

Page 8
English

section 2. general description

2.1

introduction

This manual contains information for the proper
installation, operation, and maintenance of Jandy Pro
Series VS-FHP variable speed pumps. Procedures in this
manual must be followed exactly. To obtain additional
copies of this manual, contact Zodiac
at 800.822.7933. For address information, see the back
cover of this manual.
2.2

description

The VS-FHP is a variable-speed pump that can be run
from 600 RPM to 3450 RPM. When connected to the
JEP-R controller, up to eight (8) speed settings may be
programmed and recalled. This allows you to select the
most appropriate speed for your application. Even more
versatile programming is possible when you use an
AquaLink RS or AquaLink PDA controller.
®
The pump is driven by a variable speed PMSM
(Permanent Magnet Synchronous Motor) directly
attached to the pump impeller. The motor spins the
impeller which forces water to flow through the pump.
As the speed of the motor is varied the flow through
the pump is also varied. The adjustable flow rate allows
for optimization of flow during the varying pump cycle
requirements. As a result the energy efficiency of the
pump is maximized resulting in cost savings to the pool
owner while also helping to save the environment.
Figure 2. Typical piping installation
Jandy Pro Series VS FloPro
®

section 3. installation information

3.1
3.1.1
Customer Service
®
3.1.2
noTE
noTE
|
Variable-Speed Pump Installation & Operation Manual
™

plumbing

preparation information
1. Upon receipt of the pump, check the carton for
damage. Open the carton and check the pump
for concealed damage, such as cracks, dents or a
bent base. If damage is found, contact the shipper
or distributor where the pump was purchased.
2. Inspect the contents of the carton and verify
that all parts are included, see Section 7.1,
Replacement Parts List and Exploded View.

pump location

1. Zodiac Pool Systems, Inc. recommends installing
the pump within one (1) foot (30 cm) above
water level. The pump should not be elevated
more than a few feet above the water level of the
pool.
To achieve better self-priming, install the pump as
close as possible to the water level of the pool.
2. If the pump is located below water level,
isolation valves must be installed on both the
suction and return lines to prevent back flow
of pool water during any routine or required
servicing.
When the pool equipment is located below the pool
surface a leak can result in large scale water loss
or flooding. Zodiac Pool Systems, Inc., cannot be
responsible for such water loss or flooding or damage
caused by either occurrence.
AQUAPURE
MANUAL BY-PASS DETAIL
MANUAL BY-PASS IS USED
WHEN FILTRATION RATE
EXCEEDS 125 GPM