Arrue Derby Manual De Instrucciones página 8

INSTRUCTIONS
GB
Stroller assembling
Lift the handlebar up, until security device engages correctly.
Tray
Push the tray, until the axles between the wheels.
Wheels
Push the clip of the cap in the center of the wheels and slide it into the axle until it stops.
Make sure that the wheel is fitted securely. To remove, pull them out from the axle.
Brake
To apply direct brake in rear wheels, press central bar down (A5). To release the brake,
lift it up.
Stroller use
Choose preferred seat (reaward of forward) facing position. In order to change facing
position, release side security fasteners, sliding the red latches in then direction of the
arrow (A6). Then lift seat from chassis.
14
To re-assemble, locate the two forward seat pins in the slots on the chassis (B6). Then
locate the rear pins in the corresponding slots. The seat will be correctly attached when
it "clicks". Secure it before use.
7
The seat can be reclined to a choice of positions. Lift the lever and fix desired position.
2
8
Slide the bottom lever to lift the footrest up or down.
3
9
The bumperbar upholstery can be simply removed by unzipping the zip located on the
underside, to easy cleansing. Unscrew nuts to fully remove bumperbar.
4
10
Press both side buckles (A10) in order to unfasten the harness. Children should be harnessed
in at all times. Sit the baby in the stroller and then insert the buckles again (B10), adjusting
5
the length of the strap. For extra safety, a harness may be used in addition to provided D
rings (Security strap 45).
11
(this accessory is not included)
6
Insert the two hood arms into the retainers located on both sides of the seat unit. Attach
the apron using the poppers. To remove, press hood arm clips in at the buttom and pull it
away.
Reclining back
Reclining footrest
Bumperbar
Safety harness
Hood and Apron
15