Maintenance - Ryobi PBF100 Manual Del Operador

APPLY POLISH TO SURFACE
See Figures 6 - 7, page 9.
WARNING:
To prevent loss of control and possible serious personal
injury, always operate the tool with both hands. For in-
creased stability, hold the polisher with your hands on
the rear handle and either the front or auxiliary handle.
NOTE: Make sure the ON/OFF switch is in the OFF ( O )
position before placing the polisher on any surface.
While holding the polisher firmly against the surface, slide
the ON/OFF switch to the ON ( I ) position. Always start and
stop the polisher on or against the surface being polished.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts can create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
OPERATION

MAINTENANCE

NOTE: ILLUSTRATIONS BEGIN ON PAGE 8
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
Begin by polishing larger flat surfaces. Use a broad sweeping
motion in a criss-cross pattern as shown. Do not press down
on the surface with the polisher. Let the orbital action of the
polisher and polishing pad do the work.
Once flat surfaces have been covered, polish curved surfaces
such as car doors and quarter panels. Use small circular
motions.
After applying polish to the entire surface, turn polisher off
by pushing the ON/OFF switch with your thumb. Wait until
the pad stops rotating before lifting the polisher from the
surface. Remove the battery pack from the polisher.
For hard to reach areas, such as the underside of bumpers
or side mirrors, apply polish by hand.
REPLACING THE BACKER PAD
See Figure 8
If the backer pad becomes damaged or worn, it can be
replaced using the included wrench.
 Remove the battery pack.
 Slide the wench into the slot at the base of the polisher.
 Turn the pad until the wrench slides onto the spindle shaft,
preventing it from turning.
 Continue turning the pad until the backer pad is loosened
and releases from the base.
 Attach the new backer pad by reversing these steps.
7 – English