Maintenance; General Maintenance - Ryobi PCL460 Manual Del Operador

CHANGE TO BUFFING/POLISHING BONNET
See Figure 7, page 9.
WARNING:
Check polishing bonnets before each use. Make sure
they are clean and free from any loose particles or foreign
objects that may be embedded in the bonnet. Failure
to do so could cause these particles or objects to be
thrown from the tool, resulting in possible serious injury
or scratches to the surface being polished.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts can create a hazard or cause
product damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
OPERATION

MAINTENANCE

NOTE: ILLUSTRATIONS BEGIN ON PAGE 9
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
The reusable buffing/polishing bonnet is made of synthetic
tufted material and is used to buff and polish painted surfaces.
Remove the battery pack from the buffer/polisher and remove
the application bonnet by pulling the bonnet edges over and
off the pad. Replace with buffing bonnet, attaching it the
same way as the application bonnet.
Buff the surface in the same order as it was polished, starting
with large flat surfaces and ending with hard-to reach areas.
Use the same motion as for polishing, a broad sweeping criss-
cross pattern on large flat areas and small circular motions
on all other areas. Remember to let the tool do the work.
REUSABLE BONNETS
Both the application and buffing/polishing bonnets are reus-
able. For maximum life and performance, remove and hand
wash after use, allow them to air dry, and store separately. If
needed, the bonnets can be machine washed in cold water
with a small amount of detergent, then machine dried using
low heat.
FOAM PAD
It is important that the pad retain its original shape and di-
mensions. Allow it to dry completely after each use. Store
buffer with the pad facing up to extend pad life and retain
its shape.
7 – English