Read This First - JVC GZ-MS130 Manual De Instrucciones

How to use the Touch
Sensor
After the menu is displayed on the LCD monitor:
VIDEO
MANUAL SETTING
LIGHT
REGISTER EVENT
VIDEO QUALITY
USE DETAIL SETTINGS BASED
SET
Q Slide your finger up and down on the sensor.
R Select [SET]. (Touch OK.)
A
B
A
To select an on-screen button appearing on
the left side, touch the portion of the sensor
next to the on-screen button.
B
To select an on-screen button appearing at
the bottom of the screen, touch the buttons
underneath them.
Read these INSTRUCTIONS
to enjoy your CAMCORDER.
For more details on the
operations, refer to the
GUIDEBOOK in the supplied
CD-ROM.
In order to view the
GUIDEBOOK, Adobe
® ®
Adobe Reader must be installed.
® ®
Adobe Reader can be loaded from Adobe's
web site:
http://www.adobe.com/
NOTE
Select your desired language with a single
click.
The model name is indicated on the bottom of your
camcorder.
QUIT
® ® TM
Acrobat Reader or

Read This First!

Make a backup of important recorded data
It is recommended to copy your important
recorded data to a DVD or other recording media
for storage. JVC will not be responsible for any
lost data.
Make a trial recording
Before the actual recording of important data,
make a trial recording and play back the recorded
data to check that the video and sound have been
recorded correctly. We recommend you to use the
same recording media when performing both the
trial recording and the actual recording.
Reset the camcorder if it does not operate
correctly
Close the LCD monitor and remove the power
supply (battery pack or AC adapter) from the
camcorder, then reattach it.
Precautions on handling batteries
•
Be sure to use the JVC BN-VF808U/VF815U/
VF823U battery packs. This product includes
patented and other proprietary technology and
is made to be used with the JVC battery and
not with other batteries. JVC cannot guarantee
safety or performance of this product when it is
operated by other batteries.
•
If the camcorder is subjected to electrostatic
discharge, turn off the power before using it
again.
If a malfunction occurs, stop using the
camcorder immediately and contact www.jvc.
com or by phone at 1-800-252-5722
Recorded data may be erased while the
camcorder is being repaired or inspected. Back up
all data before requesting repairs or inspections.
Because camcorder may be used for
demonstration in a shop, the demonstration
mode is set to on by default
To deactivate the demonstration mode, set [DEMO
MODE] to [OFF].
When Using an SD Card
•
Operations are confirmed on the following SD
cards. Class 4 or higher compatible SD or SDHC
card Panasonic, TOSHIBA, SanDisk, ATP SD
card (256 MB to 2 GB) or SDHC card (4 GB to
32 GB)
•
If other media are used, they may fail to record
data correctly, or they may lose data that had
already been recorded.
•
MultiMediaCards are not supported.
EN9