Read This First - JVC GZ-X900 Manual De Instrucciones

How to use the Touch
Sensor
After the menu is displayed on the LCD
monitor:
Q
Slide your finger up and down on the
sensor.
R
Select [SET]. (Touch OK.)
A
To select an on-screen button appearing on
the left side, touch the portion of the sensor
next to the on-screen button.
B
To select an on-screen button appearing at
the bottom of the screen, touch the buttons
underneath them.
Read these INSTRUCTIONS to enjoy your
CAMERA.
For more details on the operations,
refer to the GUIDEBOOK in the
supplied CD-ROM.
In order to view the GUIDEBOOK,
Adobe Acrobat Reader
® ®
must be installed.
Adobe Reader can be loaded from Adobe's
® ®
web site:
http://www.adobe.com/
NOTE
Select your desired language with a single
click.
The model name is indicated on the bottom of
your camera.
or Adobe Reader
TM ® ®

Read This First!

Make a backup of important recorded data
It is recommended to copy your important
recorded data to a DVD or other recording
media for storage. JVC will not be responsible
for any lost data.
Make a trial recording
Before the actual recording of important data,
make a trial recording and play back the
recorded data to check that the video and
sound have been recorded correctly.
Reset the camera if it does not operate
correctly
Open the LCD monitor and remove the power
supply (battery pack or AC adapter) from the
camera, then reattach it.
Precautions on handling batteries
•
Be sure to use the JVC BN-VF908U/
VF808U battery packs. This product includes
patented and proprietary technology and is
made to be used with the JVC battery only.
JVC cannot guarantee safety or
performance of this product when it is
operated by other batteries.
•
If the camera is subjected to electrostatic
discharge, turn off the power before using it
again.
If a malfunction occurs, stop using
the camera immediately and contact
www.jvc.com or by phone at 1-800-252-
5722
•
Recorded data may be erased while the
camera is being repaired or inspected. Back
up all data before requesting repairs or
inspections.
Because cameras may be used
for demonstration in a shop, the
demonstration mode is set to on by default
To deactivate the demonstration mode, set
[DEMO MODE] to [OFF].
11
EN