Switching On And Off; Working With The Implement - Grizzly ERV 1400-35 Manual De Instrucciones

2. Pull up the adjusting knob (see
no. 12). Turn the knob as appropriate
and push it down to snap in. Use your
other hand to hold the appliance.
The setting button is not intended
for height adjustment but rather to
compensate for wear. Selection of
a readjustment position without the
corresponding wear can overload
the motor and damage the cylinder.

Switching on and off

Before switching on the imple-
ment ensure that it is not in
contact with any objects. Keep
your feet and hands well away
from the cylinder and the ejector
opening. Danger of injury!
1. Place the implement on a level
E
lawn surface.
2. Form a loop in the end of the
power cable and hang it into the
strain relief (17).
3. Connect the implement to the
mains voltage.
4. To switch on press the unlocking
button on the handle (16) and
simultaneously press the starting
lever (18). Release the unlocking
button (16).
5. To switch off release the starting
lever (18).
Overload protection: The motor is
automatically switched off when the
implement is overloaded. Release
the starting lever and reset the imple-
ment after a cooling down period of
approx. 1 minute.
WARNING! The cylinder con-
A ,
tinues to run for a brief period
after the implement has been
switched off. Do not tilt or carry
the implement while the motor
is still running and do not touch
the cylinder while it is still rotat-
ing.Danger of injury!

Working with the implement

To maintain a well cared-for lawn it should
be aerated every 4 to 6 weeks.
Verticuting is a more intensive intervention
than aerating and should only be carried
out once a year, the best time being in
spring after the lawn has been mown for
the first time.
When working on slopes always
proceed across the slope. Be
particularly careful when walking
backwards and pulling the imple-
ment. Danger of stumbling!
The shorter the grass, the better the
lawn can be treated. Furthermore,
the implement is less stressed and
the service life of the cylinder is pro-
longed.
• The implement can be operated with
or without the collection bag.
Recommendation: Work with the col-
lection bag for aerating and without
the collection bag for verticuting.
• To ensure that the collision guard flap
closes properly, remove any earth that
may have collected on the collision
guard springs and/or the housing.
When working without the bag, check
that the collision guard flap is tightly
closed.
• Mow the lawn to the required grass
GB
55