Taurus MITHOS AVANT Manual De Instrucciones página 15

- Connect the appliance to the mains.
- Make sure that the blades are correctly aligned.
- Turn the appliance on, by using the on/off switch
HOW TO CUT THE HAIR:
- Situate the person whose hair you are going to cut so that the top
of their head is at your eye level. Place a protective towel or cloth
around their neck.
- To obtain best results is better to use the appliance on dry hair, as
it is much easier to control the hair and the results
- Comb hair well before cutting. Make sure that there are no tangles
or knots.
- Hold the appliance in calm and relaxed manner in order to ensure
maximum control of the cut and uniform result. Proceed to use
short cuts gradually going around the head.
- Leave the hair a little longer than desired length as it can always
be altered later.
- While working adapt the comb/comb guide to the desired result
- At regular intervals, stop cutting in order to comb the hair and
check the results so far.
STEP 1 – NAPE:
- Attach the comb guide size 3 / 6 mm
- Hold the appliance with the razor facing downwards and begin to
cut the hair from the base of the neck.
- Make some upward movements, raising the appliance gradually
and away from the head, cutting the hair gradually until the height
of the ears (Fig.2)
STEP 2 – BACK OF HEAD:
- Attach comb guide size 9 / 12mm and continue with the back of the
head (Fig.3)
STEP 3 – SIDE OF HEAD:
- Attach a new shorter guide, size 3 / 6 mm to trim the sideburns.
- Attach the longest comb guide size 9 / 12 mm again and continue
until you reach the top of the head.
STEP 4 – TOP OF HEAD:
- Using comb guide size 9 / 12 mm, pass the appliance from the
back to the front, against the growth of the hair (Fig.4). In some
cases it's necessary to go over what you have done a second time
from front to back.
- The comb guide size 3 / 6 mm is for when you want to achieve a