Taurus MITHOS AVANT Manual De Instrucciones página 16

more precise cut.
- Use comb guides size 12 mm to leave hair at a longer length. Hold
the hair up with the comb or the comb and your fingers and cut.
- Always work form back to the front reducing the length between
your fingers or the comb and the head gradually.
STEP 5 – FINAL TOUCH:
- Finally use the appliance without attaching any comb guides to the
blades to cut the hair around the base of the neck, the sides of the
neck and the ears.
- To make sideburns straight, turn the appliance over to use the
upper blades (Fig.5). Move the appliance adapting it the physiog-
nomy of the head. To achieve more precise results use a shaver
ONCE YOU HAVE FINISHED USING THE APPLIANCE:
- Turn the appliance off, using the on/off switch
- Unplug the appliance from the mains
- Clean the appliance
- Put on the protective cover.
CLEANING:
- Disconnect the appliance from the mains and allow it to cool befo-
re undertaking any cleaning task.
- Clean the equipment with a damp cloth with a few drops of
washing-up liquid and then dry.
- Do not use solvents, or products with an acid or base pH such as
bleach, or abrasive products, for cleaning the appliance
- Never submerge the appliance in water or any other liquid or place
it under running water.
- Clean the blades and the comb guide with the cleaning brush.
Remove the hairs from the blades and from inside the appliance
with the brush. It is important to clean off remaining hairs after
each use.
- NEVER disassemble the blades from the appliance to clean.
ANOMALIES AND REPAIR:
- Take the appliance to an authorized technical support service
if product is damaged or other problems ariseDo not attempt
to disassemble or repair the appliance yourself as this may be
dangerous.