Intended Use; Electrical Connection - Beem Fire & Sun B25.001 Manual De Instrucciones

BEEM - Elements of Lifestyle

Intended use

This appliance is only intended to be used for
toasting, baking, grilling and defrosting food
in the household or similar, non-commercial
establishments such as staff kitchens in
shops, cafés, offices or other business sur-
roundings; agricultural establishments; use
by guests in hotels, motels or other residen-
tial facilities; bed and breakfast establish-
ments.
Any use other than previously stated is con-
sidered as improper use.
WARNING
If not used for its intended purpose and/or
used in any other way, the appliance may
be or become a source of danger.
► Use the appliance only for its intended
purpose.
► Observe the procedures described in
this user manual.
No claims of any kind will be accepted for
damage resulting from use of the system for
other than its intended purpose.
The risk must be borne solely by the user.
Requirements for the place of
operation
For safe and trouble-free operation of the ap-
pliance, the installation location must satisfy
the following requirements:
Place the appliance on a stable, level,
‹
heat resistant surface that is also resistant to
splashing fat.
The surface finishes on furniture may
‹
contain substances that can be detrimental to
the feet of the appliance. If necessary, place
a mat under the feet of the appliance.
Do not place the appliance in a hot, wet
‹
or very humid environment or in the vicinity of
inflammable materials. There must be a gap
of at least 15 cm between the appliance and
any walls, furniture or other objects.
Do not install the appliance under a wall
‹
cabinet.
The mains socket must be easily accessi-
‹
ble and allow fast disconnection in the event
of an emergency.
Top prevent the appliance from slipping
‹
away, do not lay tablecloths, cloths or servi-
ettes under the feet of the appliance.
Do not place the appliance on the edge of
‹
the rest, it could fall down.
The appliance may not be used or stored
‹
outdoors.

Electrical connection

For safe and trouble-free operation of the
appliance, the following instructions on the
electrical connection must be observed:
Before connecting the appliance, com-
‹
pare the connection data (voltage and
frequency) on the rating plate with those of
your mains power supply. This data must
correspond in order to avoid damage to the
appliance. If in doubt, ask your electrical ap-
pliance retailer.
The mains socket must be protected by at
‹
least a 16 A fuse.
Ensure that the mains cable is undam-
‹
aged and is not laid over hot surfaces or
sharp edges.
The mains cable must not be pulled
‹
tightly, bent, crushed or knotted or come into
contact with hot surfaces.
Always unwind the mains lead completely
‹
before connecting the appliance to the plug
socket.
If the appliance is to be connected to the
‹
power supply via an extension lead, the cable
cross-section must be at least 1.5 mm².
The electrical safety of the appliance is
‹
only assured when it is connected to a prop-
erly installed protective earth (PE) conductor
system. Connection to a mains socket with-
out PE conductor is forbidden. If in doubt, the
electrical system must be checked by a quali-
fied electrician. The manufacturer assumes
no liability for injury or damage caused by a
missing or interrupted protective earth con-
ductor.
Route the mains cable to prevent risk of
‹
tripping.
EN 15