!
Read the operating instructions and the enclosed brochure „Guarantee and additional notices"
completely. Follow the instructions they contain. Safely keep these documents for future reference.
The automatic cross-line laser with integrated hand receiver mode for aligning tiles,
wall studding, windows, doors etc.
General safety instructions
periods of storage. We also wish to point out that absolute calibration is only possible in a specialist workshop.
Calibration by yourself is only approximate and the accuracy of the calibration will depend on the care with which
you proceed.
!
Always turn off all lasers and latch the pendulum in place before transporting,
ON/OFF switch in its „OFF" position!
Inserting batteries
1
Open the battery compartment
and insert batteries (4 x type AA)
according to the symbols. Be sure
to pay attention to polarity.
Laser radiation!
Do not stare into the beam!
Class 2 laser
< 1 mw · 635 nm
EN 60825-1:2007-10
SmartLine-Laser 360°
Caution: Do not look directly into the beam. Lasers must
be kept out of reach of children. Never intentionally aim
the device at people. This is a quality laser measuring
device and is 100% factory adjusted within the stated
tolerance. For reasons of product liability, we must also
draw your attention to the following: Regularly check the
calibration before use, after transport andafter extended
–
+
+
–
07
GB