LaserLiner SmartLine-Laser 360 Manual De Instrucciones página 9

3 Hand receiver mode
Optional: Working with the laser receiver RX
Use an RX laser receiver (optional) to carry out levelling at great distances
or when the laser lines are no longer visible. To work with a laser receiver,
switch the line laser to hand-held receiver mode by keeping button 6
(handheld receiver mode on / off) pressed. The laser lines will now pulsate
with high frequency, making the laser lines darker. The laser receiver can
detect these pulsating laser lines.
!
Observe the laser receiver's operating instructions for line lasers.
Due to the special optics required to generate a continuous 360° laser line, the underlying technology
!
may cause differences in brightness in different areas of the line. This may lead to different ranges in
hand receiver mode.
4 Slope mode
Do not release the transport restraint, set the ON/OFF switch to „OFF". Select and switch on the laser with
the selection button. Sloping planes can now be measured. This mode cannot be used to perform horizontal
or vertical levelling as the laser lines are no longer aligned automatically. The LED lights constantly red.
LASER LASER LASER LASER
SmartLine-Laser 360°
LASER
3 Sek.
09
GB