HQ-Power VDPLBL8 Manual Del Usuario página 4

4. Use
Switch on your VDPLBL8. The LCD will show the following message:
HQ POWER
LED EIGHT blinder
Press the MODE button to activate the main menu. Following options appear:
1. Built-in program: possibility to choose one of the 14 built-in programs.
2. Auto run: Possibility to run the built-in programs sequentially in a continuous loop.
3. DMX mode: control by means of a DMX controller.
4. Slave mode: Synchronous operation of different VDPLBL8s.
5. Sound mode: Sound-activated operation.
1. Built-in Programs
A program is a sequence of different steps. Press SET UP and select the desired program with UP or DOWN. Next,
determine the desired program value (SP: step time value from 001 to 100; FS: flash speed from 00 to 100).
02. SLOW DREAM
SP: 001 FS: 012
2. Auto Run
AUTO RUN
FREQUENCY: 001
3. DMX Mode
Control different VDPLBL8s individually via a DMX controller.
a. Addressing
DMX MODE
dmx address: 001
b. DMX Protocol
DMX MODE
channel num: 26
desired channel configuration with UP or DOWN.
• 26-channel Configuration
The dimmer function occupies the first channel, the flash function occupies the second
channel, each spot occupies 3 channels.
VDPLBL8
Example: Press SET UP and choose program (e.g. 02) with UP or DOWN. Set
the desired step time and flash speed.
With this function you can run all 14 programs in a continuous loop. Set the
frequency value, i.e. running time, by means of the UP or DOWN button.
The control board on your VDPLBL8 allow you to assign the DMX address
which is defined as the first channel from which your VDPLBL8 will respond to
the controller. Set the address using the UP or DOWN button.
The control board allows you to set a 5, 8, 14 or 26-channel configuration for
different applications. Press SET UP to select the DMX protocol setting, set the
4 VELLEMAN