Inserting The Batteries - LaserLiner LuxTest-Master Manual De Instrucciones

Safety instructions
– The device must only be used in accordance with its intended
purpose and within the scope of the specifications.
– The measuring tools and accessories are not toys.
Keep out of reach of children.
– Do not expose the device to mechanical stress, extreme temperatures,
moisture or significant vibration.
Calibration
The meter needs to be calibrated and tested on a regular basis to ensure
it produces accurate measurement results. We recommend carrying out
calibration once a year.

Inserting the batteries

1
Open battery compartment and insert
batteries corresponding to installation
symbols. Ensure correct polarity.
ON/OFF
2
5
Automatic switch-off after
10 minutes.
Measuring range (manual/automatic)
4
After being switched on, the measuring instrument
always starts set to the automatic measuring range.
Press the „MAN/AUTO" button to change over to
manual measuring range. The measuring range, i.e.
the decimal place (20.00 lux; 200.0 lux; 2,000 lux;
20,000 lux; 200,000 lux) changes with each additional press of the button.
„OL" will appear in the display when the measured value is outside the
08
GB
Button tones
3
With the device switched
on, briefly press and hold
the „ON/OFF" button
to deactivate the button
tones. Press the button
1 sec
again to reactivate the
button tones.
6LR61 9V
5