Relative Measurement; Units Of Measure - LaserLiner LuxTest-Master Manual De Instrucciones

measuring range. Press the „MAN/AUTO" button
until the corresponding manual measuring range
is set or until „AUTO" appears in the display,
indicating that the automatic measuring range is
set again.

Relative measurement

5
After switching on the device, activate relative
measurement by pressing the „REL/PEAK" button.
The value last displayed will be set as the reference
value and it now shows the difference with respect
to the set reference value. The relative measurement
can be carried out both in the automatic as well as in the manual measuring
range. This function is deactivated by pressing the „REL/PEAK" button again.
Peak measurement
6
After switching on the device, activate peak
measurement by pressing the „REL/PEAK" button.
This function increases the response of the sensor,
thus enabling it to register quick changes in light
levels. Peak measurement is only possible in the
manual measuring range. Set the corresponding
measuring range as described in Step 4. Press and
hold the „REL/PEAK" button to deactivate this
function.
!
The peak value remains visible on the display. Measured values lower
than the peak value will not be displayed.

Units of measure

7
The measured values can be displayed in Lux and FC
(foot-candles). Press the „UNIT" button to change the
unit of measure.
LuxTest-Master
10
5
0
2 sec
5
0
5
0
15
20
09
GB