Capturing And Playing Back Video - Blackmagic Design UltraStudio 4K Mini Manual De Instalación Y Funcionamiento

Capturing and Playing Back Video

Once the Desktop Video hardware and software is installed, you can start capturing and
playing back clips straight away. First, plug your video source into the input on your Desktop
Video hardware, then connect a monitor to the output.
A quick way to begin capture and playback is to record a clip in Blackmagic Media Express,
which was installed on your computer when you installed the Desktop Video software.
Setting Up
1 Connect a monitor or TV to the video output of your Blackmagic Design hardware.
2 Connect a video source to the input of your Blackmagic Design hardware.
A B
REMOTE SDI OUT
HDMI OUT SDI IN
Ultra Studio HD Mini
Connect a video monitor and source to your Blackmagic Design video hardware.
Testing Video Capture
1 Launch Blackmagic Media Express. Click on the 'log and capture' tab. Your input video
format is automatically detected and Media Express sets the project video format to
match. Your video source will appear in the Media Express preview pane.
2 Click 'capture' at the bottom of the 'log and capture' window to perform the capture
test. Click 'capture' again to finish the test. The captured clip is added to the media list
on the left side of Media Express.
NTSC B-Y R-Y
PAL
Y
ANALOG VIDEO IN
CH 1 CH 2
REF IN ANALOG AUDIO IN
URSA Mini Pro
HDTV
SDI OUT
SDI IN
REF IN
TC IN
+ 12V
Capturing and Playing Back Video 14