Batch Capture with UltraStudio and DeckLink
To log clips for batch capture:
1
Choose file > input > tape capture to open the 'capture tool'.
2
If the deck is in satellite mode, click the toggle source button to change it to deck
mode. Click on the 'capture/log mode' button so it displays the 'log' pencil icon.
3
Configure video and audio input, video and audio source tracks, target bin, res, target
drive and tape name the same way as in 'capture from non-controllable devices'.
4
Use the 'deck controller window', or use the standard j, k, l shortcut keys, to shuttle
backwards, pause and shuttle forwards on the deck and locate the video you want
to capture.
5
Click the 'mark in/out' button, to the left of the log button. The icon will alternate
between in and out so you only have to click the one button to mark all your in and
out points and log your clip. This can be more convenient that using the separate
'mark in' and 'mark out' buttons in the deck controller window. Alternatively use the
'i' and 'o' keys on the keyboard to mark in and out points, and the keyboard shortcut
'F4' to log the clip.
Click on the 'mark in/out' button or use the 'i' and 'o'
keys on the keyboard to mark in and out points.
6
When you have finished logging your clips, close the capture tool, open the logging bin
and select the clips you want to capture.
7
From the 'clip' menu, choose batch capture, select the desired options in the resulting
dialog box and click 'ok'.
Using your Favorite 3rd Party Software
48