Deklaracja Zgodności Ce; Battery Care; Environmental Protection; Repairs - RIVIT RIV 760 Instrucciones De Manejo

PL
6. Deklaracja zgodności CE
2.2.2
Oświadczamy na własną odpowiedzialność, że produkty spełniają wymagania następujących
norm i dyrektyw:
• DIN EN 62841-1:2016-07
• 2006/42/WE
• 2014/35/EU
• 2014/30/EU
2.3
Dokumentacja techniczna:
RIVIT S.r.l.
Via Marconi, 20 - Loc. Ponte Rizzoli
40064 Ozzano dell'Emilia (Bologna) - Włochy
186
Manuele Avanzolini
(Szef prawne)
2 2 .4

Battery care

Caution!
If not used for longer than 21 days, the battery will switch itself off automatically to
prevent exhaustive discharge. Reactivate the battery before using again by inserting it
in the battery charger for about 2 minutes.
• To obtain an optimum charge, allow the battery to cool down before inserting it in the
charger.
• The RIVIT battery can be recharged approx. 1000 times and reaches its full capacity
after several charges.
• Do not insert the battery into the charger after each use.
• Only charge the battery when it is discharged and rivets can no longer be set. Only
recharge the battery after a prolonged idle period.
• Significantly shorter battery operating times, despite proper recharging, indicate that the
battery needs to be replaced.
• Store batteries in a dry place where there is no danger of frost. The optimum operating
temperature range is 10°C to max. 50°C.
2.5

Environmental protection

If batteries need to be replaced, please observe the following:
• Return used RIVIT rechargeable batteries to your dealer or to RIVIT for recycling.
• Never discard used batteries into household waste, fire or into water!
Caution!
In all EU countries (except Germany) the relevant national regulations for implementing
the EU guideline shall apply.
• In accordance with the EU Directive 2014/30/EU (WEEE), in Germany, this tool is
registered under the WEEE Reg.-No. DE 45695505. If the tool has an 8-digit serial number
it can be returned free of charge to RIVIT for correct disposal.
3.

Repairs

Repairs under warranty are carried out by the manufacturer. Repairs outside the warranty
period should only be carried out by skilled technical personnel. Failure to observe the
assembly and setting procedures and operation by non-skilled personnel may result in serious
damage to the riveting tool. In case of doubt, always send the riveting tool back to the supplier
or to RIVIT.
GB
27