Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Contents
Exploded Drawing
Declaration of CE-Conformity
1
1.1
1.2
1.3
2
2.1
2.2
3
4
5
6
6.1
7
8
9
10
11
2
21
22
25
25
25
26
26
26
26
27
28
28
29
30
30
31
32
33
33
20
Declaration of CE-Conformity
We, the manufacturers of the equipment, hereby declare under our sole responsibility that
the product(s) described below conform to the essential safety requirements. This
declaration will be rendered invalid if any changes are made to the equipment without
prior consultation with us.
Manufacturer
Kärntner Str. 18 - 30
Fax: +49(0)202 / 787 - 2217
Type Designation
Manual Spray Guns PILOT Trend
PILOT Trend
PILOT Trend-MP Gravity-Feed Cup
PILOT Trend-MP Material Connection
Intended purpose
Processing of sprayable media
Applied Standards and Directives
EU-Mechanical Engineering Directives 2006 / 42 / EC
94 / 9 EC (ATEX Directives)
DIN EN ISO 12100-1
DIN EN ISO 12100-2
EN 1127-1
Specification according 94 / 9 / EC
Category 2
Part marking
Authorized with the compilation of the technical file:
Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30
D- 42327 Wuppertal
Special remarks :
The named product is intended for installation in other equipment. Commissioning is
prohibited until such time as the end product has been proved to conform to the
provision of the Directives 2006 / 42 / EC.
Wuppertal, the 1st of December 2014
p.p.
Name: Torsten Bröker
Position: Manager, Design and Development
This Declaration does not give assurance of properties in the sense of product liability. The safety
instructions provided in the product documentation must be observed at all times.
Gravity-Feed Cup
V 10 601
Material Connection
V 10 602
V 10 611
V 10 613
DIN EN 1953
DIN EN 13463-1
Tech.File,Ref.:
II 2 G c T 6
2413
21
Publicidad
Capítulos
Tabla de contenido
