Rs 232 Output - Giropes Baxtran XTA Manual De Usuario

Then press the calibration switch to access to calibration.
• Press key to confirm for calibration, display will be show "
• Remove the goods from the platform and make sure STABLE indication has been enable.
• Press key to confirm.
• Display will be show ,CAP LoAdXX.
• If necessary change the calibration weight value by pressing
key to confirm when display gets stable, display will be show PASS.
• Press
Finished calibration and display will come to FO CAL.
• Remove calibration weigjt from the platform.
• Press key for to go back to the weighing mode.

9. RS 232 OUTPUT

1. SPECIFICATIONS:
RS-232 output of weighing data
ASCII code
1200~115200 Baud
8 data bits
No Parity
2. RS-232 (9PIN D TYPE CONNECTOR)
Pin 2
Pin 3
Pin 5
9PIN D CONNECTER:
Scale
Pin 2
Pin 3
Pin 3
3. CONTINUOUS & STABLE OUTPUT PROTOCOL
"CONT":
S T , G
-HEADER 1- -HEADER 2-
4. COMMUNICATION PROTOCOL
RXD Input
TXD Output
GND -
Computer
Pin 3
Pin 2
Pin 5
S : - +/-
UNLOAD
"
key and place the callibration weight on the platform.
Receiving data
Transmission data
Signal ground
- WEIGHT DATA -
USER MANUAL XTA EN
g
k CR LF
-WEIGHT UNIT- -TERMINATOR-
17