Unsafe Vehicle Seat Belt Systems; Weight And Height Limits - Graco BOOSTER DELUXE Manual Del Propietário

English
EN
Assembling the booster seat
1
To adjust armrests, remove screw and press in button
on side of base as shown to raise or lower. Reinsert
screw and tighten. CHECK to make sure armrests are
securely attached by pulling up on them.
3
Slip armrest covers (on certain models) onto armrests
as shown.
4
Your Graco booster seat is now ready to use. See
"Securing Child in Vehicle with Shoulder Belt
positioning Clip".

Weight and Height Limits

FAILURE TO USE booster seat in a manner appropriate for
your child's size may increase the risk of serious injury or
death.
To use this Graco booster seat, your child MUST meet ALL of
the following requirements:
5
Without back support (approximately 6 to 12 years old):
weigh between 22-36 kg, and
are between 125 and 150 cm in height, and
the shoulder belt MUST lay across child's shoulders
in red zone as shown in
positioned low on the child's hips, and
when sitting on the booster seat, your child's ears are
below the top of the vehicle seat cushion / head rest.
your Graco booster seat can be used with or without the
back support (on certain models) as long as the above
requirements are met.
2
5
and the lap portion is
9

UNSAFE Vehicle Seat Belt Systems

DO NOT use any of the following vehicle belt systems.
6
NEVER use a lap-only belt.
7
NEVER use a passive restraint lap or shoulder belt
mounted on door.
Vehicle belts MUST lay flat against child and MUST not be
twisted.
8
The shoulder belt MUST lay across child's shoulders in
red zone as shown.
If shoulder belt lays outside this zone, the shoulder belt
positioning clip MUST be used.
DO NOT position vehicle belt over top of the armrests.
It must pass underneath the armrests.
Make sure vehicle belt is NOT twisted.
Lap portion of lap/shoulder belt MUST be low and snug
on hips, just touching thighs.
To attach clip to booster seat
9
Insert the loop end of strap around vertical bar on rear
of seat as shown. The shoulder belt positioning clip
MUST be attached onto the vertical bar of the base
farthest from where the vehicle shoulder belt lays
across the child.
10
Pass the clip and strap through the loop end as shown
and pull strap up.
11
NOTE: Free end of strap should face front of seat.
12
Slide the vehicle shoulder belt onto the clip as shown
and pull strap down to tighten clip against child's
shoulder.
10