Display Error Codes; Disposal; Declaration Of Conformity For Mid Meters - Diehl Sharky 774 Instrucciones De Montaje

9.

Display Error codes

If an error occurs, the error code is displayed in the main loop. All win-
dows, however, can still be accessed by pressing the button. If the button
is not pressed for approx. 4 min, the error code is automatically displayed
again.
The error message disappears automatically as soon as the source of the
error is corrected. All errors that exist for longer than 6 min, are saved in
the error memory.
Error code Description
C - 1 Basic parameter error in flash or RAM - Meter must be replaced
E 1 Temperature range outside [-19.9 °C...199.9 °C] e.g. sensor short-circuit,
sensor break
E 3* Forward and return sensor reversed
E 4 Hardware error US measurement, e.g. transducer or control defective or short
circuit
E 5 Communication not possible (too frequent read-out)
E 6* Flow direction of flow meter incorrect
E 7 No plausible ultrasound receiver signal, e.g. air in the measuring path
E 9 Battery nearly discharged, design lifetime reached
* application dependent
10.

Disposal

This product must be disposed of separately. Contact a designated collec-
tion point for old batteries or your Diehl Metering specialist dealer.
11.

Declaration of conformity for MID meters

See from page 51 onwards.
Further information as well as the actual declaration of conformity are
available at:
https://www.diehl.com/metering/en/support-center/download-center/
-26-
English