Handicare Carina350EM Manual De Usuario página 5

Assembly
3
Check to ensure that the following components are included
Mast with lift arm, lift motor, sling bar and control box.
Undercarriage with base-width adjustment pedals.
Quick-connecting locking pin for mounting actuator.
Hand control and cord.
Locking handle for mounting mast on undercarriage.
User manual.
Charging cord.
The lift is collapsed when delivered. Set up the lift, according to the following instructions
(no tools required)
1. Lock castor brakes.
2. Loosen the locking handle at the base of the mast (image 1).
3. Pull the mast forward, lift it up and place it in the base.
4. Tighten locking handle (image 1).
5. Loosen the tension strap that holds the lift arm and lift up the lift arm.
6. Remove the actuator from the mount on the mast and move it to the mount on
the lift arm (image 2).
7. Check all mounting fixtures and locking handles (images 1 and 2).
8. Deactivate the emergency stop (image 3) and perform a final inspection (see Final
inspection).
3
To collapse the lift, follow the instructions below
1. Lock castor brakes.
2. Run the lift arm to the lowest position, and then press in the emergency stop.
3. Remove the actuator from the lift arm by freeing the quick-connecting locking pin
and moving it to the mount on the mast (diagram 4). Make sure the pin is facing the
right way up.
4. Lower the lift arm and secure it to the link on the sling bar with the tension strap.
NOTE! Warning for risk of pinching (between boom and mast).
5. Loosen the locking handle at the base of the mast (image 1). The locking handle
doesn´t need to be removed.
6. Lift up on the mast and lower it towards the undercarriage.
7. Pull the mast back and tighten the locking handle (image 1)
3
SystemRoMedic
M A N U A L
TM
4
4
4
5
REV. POS.
5
REV. POS.
5
6
REVISION HISTORY
DESCRIPTION
1
2
6
REVISION HISTORY
DESCRIPTION
3
4
No burrs allowed
Break sharp edges: Rmax:0.3 mm / 0.3 mmx
Replaces drawing/part number (Linido Part N
Unless otherwise stated, general tolerances a
Omitted dimensions according to
[90003465_06_Carina350EM.dwg/step]
NAME
hc-laek
CREATED
Released
STATUS
SCALE PROJECTION
1:20
6
This drawing and any information or descriptive matter set out hereon ar
and must not be disclosed, loaned, copied or used for manufacturing, te
7
7
DATE TITLE
2015-03-05 C
SIZE D
A3
MATERIAL
Mate
MATERIAL
WEIGHT:
5