Steren K-720 Manual De Instrucciones página 64

TROUBLESHOOTING
1. Ensure batteries are placed in correct polarity.
2. If when you press the 0n/off button the LED lights do not flashing and the robot is not
work, ensure that the screws are fastened until bottom (refer to p.45).
3. Ensure all wiring are correct connected and with wire configuration as shown below
(refer to p.46).
Black Blue
Black Red
4. Don't play under the solar beam or halogen lamp, may cause interferences and go to in
wrong direction.
5. If while you playing the robot emits a "beep-beep" means low battery alert and you must
to replace the batteries.
6. Under the explorer mode, if you can hear an abnormal noises and the gearbox still
working but the robot do not move, verify:
Refer to p. 55 ensure that the A19 piece is placed corectly.
Refer to p. 40 and ensure that the A15 piece was removed.
Refer to p. 40 & 45 and check that the screws are fastened firmly.
7. If the robot walking unstable or tumbling, check that don't mix the A1 and A2 pieces (refer
to 52 and 56).
64