Important; Air Conditioner Use; Starting Your Air Conditioner; Fan Speed - Amana ACD10KE Manual De Uso

Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.

IMPORTANT:

If you turn off the air conditioner, wait at least 3 minutes before
■
turning it back on. This keeps the air conditioner from blowing a
fuse or tripping a circuit breaker.
1. Remove the clear plastic film from the control panel.
2. Press POWER to turn on the air conditioner. The Power
indicator light will turn on.
NOTE: When the air conditioner is plugged in, the LED display
will show "88" for 3 seconds. After the air conditioner is turned
on for the first time, the display will show the current room
temperature and the fan is set to Low speed.
After the unit is plugged in, but before the unit is turned
on, press and hold the POWER button for 5 seconds to
switch the temperature display between Fahrenheit (F) and
Celsius(C) degrees.
3. Select mode. See "Mode."

AIR CONDITIONER USE

Do not try to operate your air conditioner in the Cool mode when
■
outside temperature is below 61°F (16°C). The inside evaporator
coil will freeze up, and the air conditioner will not operate
properly.

Starting Your Air Conditioner

4. Select fan speed. See "Fan Speed."
5. Set temperature. See "Temperature."
Mode
1. Press MODE until you see the indicator light glow for the
desired setting.
2. Choose Fan, Cool, Energy Saver or Dehum.
Fan—Only the fan runs. Press SPEED to select High, Med
■
or Low fan speed. The display shows the current room
temperature.
Cool—Cools the room. Press SPEED to select High, Med or
■
Low fan speed. Press the TEMP/TIME up or down
arrow button to adjust the temperature.
Energy Saver—Fan runs only when cooling is needed. Press
■
SPEED to select High, Med or Low fan speed.
Because the fan does not circulate the room air continuously,
less energy is used, but the room air is not circulated as often.
Dehum—Dries the room. The air conditioner automatically
■
selects the temperature.
NOTE:
Dehum mode should not be used to cool the room.
■
In Dehum mode,Please do not operate the speed button.
■

Fan Speed

1. Press FAN SPEED until you see the indicator light glow for
the desired setting.
2. Choose High, Med or Low.
High—for maximum cooling
■
Med—for normal cooling
■
Low—for minimum cooling
■
9