Peg-Perego uno Instrucciones De Uso página 17

5 Slide the ring into the basket fabric (fig_a) and push
it into the housing on the stroller until it clicks into
position. Clip the basket onto the buttons on the side
(fig_b) and slip the two loops onto the stroller at the
front. (fig_c).
6 The stroller basket has three positions. The normal
position can be seen in Figure A. The basket can be
lowered to allow it to be used even when the backrest
is completely lowered. By pressing on it, it is easier
to fill it without disturbing the baby (fig_b). The
basket can also be raised to allow access to the rear
footboard (fig_c).
7 FRONT BAR: insert the front bar (fig_a) and press
until the first click. Pull the levers under the front
bar towards you (fig_b) and insert it completely by
pushing it forwards (fig_c).
8 The front bar can be lengthened to two positions.
To move it to the first position, pull the two levers
underneath towards you (fig_a) and pull it until the
first click (fig_b). To move it to the second position,
pull the two levers and the front bar towards you
again until the second click (fig_c).
When your children are bigger, you can remove the
front bar. Press the buttons under the armrests (fig_d)
while pulling the front bar outwards at the same time
(fig_e).
9 CHILD TRAY: pull the front bar out to the second
position and attach the tray by pushing it downwards
(fig_a). You can remove it by pushing the two side
flaps of the tray outwards and lifting the tray at the
same time (fig_b).
10 BRAKE: to set the brake on the stroller, lift the lever on
the side of the handlebar (fig_a); to release the brake,
disengage the lever by pushing the release button
(fig_b). Always set the brake when the stroller is not
moving.
11 5-POINT SAFETY HARNESS: to attach the safety
harness, insert the two buckles of the waist strap
(with shoulder straps attached – arrow_a) into the
leg divider strap until it clicks into place (arrow_b). To
release, push the round button placed in center of the
buckle upwards (arrow_c) and pull the waist strap to
the sides (arrow_d).
12 To tighten the waist strap, pull on both sides in the
direction of the arrow (arrow_a). To loosen it do the
opposite. The waist strap can be tightened as far as
the safety lock (fig_b).
13 To adjust the height of the safety harnesses, release
the two buckles on the rear of the backrest.
Pull the shoulder straps towards you (arrow_a) until
the buckles are released and insert them in the
backrest loops (arrow_b). Remove the shoulder straps
from the sack (arrow_c) and insert them in the most
appropriate loop (arrow_d), then re-attach the two
buckles on the rear of the backrest (arrow_e).
14 ADJUSTING THE BACKREST: the stroller backrest can
be reclined in three positions. To lower it, raise the
handle (fig_a) and at the same time lock it into the
desired position (fig_b); push upwards to raise it.
15 ADJUSTING THE FOOTREST: the footrest has
two positions. To lower it, pull the two switches
downwards and lower the footrest at the same time
(fig_a). To raise it, pull it up until it clicks (fig_b).
16 SWIVEL WHEELS: the smaller wheels on the stroller
swivel. To make them swivel, raise the lever (fig_a).
Lower the level to set them in their fixed position
(fig_b).
17 HANDLEBAR: to make the handlebar reversible,
pull the clips on it upwards at the same time (fig_a)
and move it to the other side until the final click.
IMPORTANT: take care not to hurt the child's hands
or arms when doing this. Adjust the height of the
handlebar by pressing on both side buttons at the
same time (fig_b).
18 DRINK HOLDER: Click the drink holder into place.
19 The seat of UNO model Soft is reversible. Before
proceeding, remove the straps and replace them
once the operation has been completed. To reverse
it, unbutton the upper sack from the lower sack in
the footrest area (fig_a), open the zipper along the
backrest (fig_b) and re-position the sack from the
opposite side.
20 CARRIAGE AND/OR STROLLER: Uno becomes a
carriage when the backrest is in its lowest position,
the footrest is raised, the handlebar is on the opposite
side to the backrest and the swivelling wheels are
also on the opposite side to the backrest (fig_a). Uno
becomes a stroller when the backrest is raised, the
footrest is lowered, the handlebar is on the same
side as the backrest and the swivel wheels are on the
opposite side to the backrest (fig_b).
21 HOOD: turn back the front edge of the hood (fig_a),
insert the clips in the slots in the stroller arms (fig_b)
and button them to the rear of the backrest. Button
the hood to the insides of the armrests (fig_c) and
stretch it, lowering the joints (fig_d). To transform
the hood into a sun canopy, open the zip (fig_e) and
unbutton the rest of the hood.
22 COVER: to transform Uno into a carriage, first
lengthen the front bar to the second position and
raise the footrest, slide out the lower part of the
cover from under the footrest sack and insert the
tabs of the lower part of the front cover in the slots
of the front bar (fig_b). The slots in the front bar will
come out when the front bar is lengthened. If the
slots slide back into position, push the two levers
under the front bar towards you. Finally, slip the side
eyelets onto the armrests (fig_c). The carriage version
without a cover can be seen in Figure D.
23 Zip the upper part of the cover to the lower part, slip
the side eyelets onto the armrests in sequence (fig_a)
and button the cover to the armrests (fig_b). The
carriage version with a cover can be seen in Figure C.
24 REMOVING THE WHEELS: to remove the large wheels,
press the button (fig_a) and slide the wheel out
(fig_b). To remove the small wheels, press the switch
inwards (fig_c) and slide out the wheel at the same
time (fig_d).
CLOSING: Before closing the stroller, make sure that
the handlebar is positioned on the backrest side and
ensure that all the wheels are in the fixed position. If
the hood is on, loosen the joints.
25 To close the stroller, press lever 1 and then lever
2 (fig_a), turn the handlebar forwards and push it
downwards. Complete the procedure by fastening
the clips (fig_b). When the UNO stroller is closed, it is
freestanding.
26 TRANSPORT: the stroller has two carrying handles on
the sides that allow it to be transported both when
closed and when open (for example, when going
down stairs).
27 REMOVING THE COVER: To take the cover off the
stroller, remove the tab of the fabric covering from
the backrest (fig_a) and pull the others out of the
armrests (fig_b). To release the lower part of the cover
for washing, detach the fasteners from the points on
the frame of the footrest (fig_C).
THE GANCIOMATIC SYSTEM
The swift, practical Ganciomatic System allows you
to attach the Primo Viaggio car seat (sold separately)
to the Ganciomatic points on the stroller in one easy
step.
28 GANCIOMATIC POINTS ON THE STROLLER: to raise the
Ganciomatic points on the stroller, lift the sack at the
corners of the seat and turn the two points upwards
(fig_a). To lower the Ganciomatic points on the
stroller, pull the switch upwards and lower the point
- 17 -