Panel Mounting; Connecting 1762 I/O Expansion Modules - Allen-Bradley MicroLogix 1200 1762-L24AWA Instalación, Operation Y Mantenimiento

Panel Mounting

Mount to panel using #8 or M4 screws. To install your controller using mounting
screws:
1. Remove the mounting template from inside the back cover of this document.
2. Secure the template to the mounting surface. (Make sure your controller is
spaced properly. See Controller Spacing on page 11.)
3. Drill holes through the template.
4. Remove the mounting
template.
5. Mount the controller.
6. Leave the protective debris
strip in place until you are
finished wiring the controller
and any other devices.

Connecting 1762 I/O Expansion Modules

ATTENTION
Connect 1762 I/O after mounting the controller. Remove the expansion port cover
to install expansion I/O modules. Plug the ribbon cable connector into the bus
connector. Replace the cover as shown below.
Remove power to the system before installing expansion I/O
or damage to the controller may result.
MicroLogix™ 1200 Programmable Controllers
Mounting
Template
Publication 1762-IN006D-MU-P - March 2004
13