Rockwell Automation Allen-Bradley MicroLogix 1500 1764-24AWA Instalación E Instrucciones De Operación página 12

12 MicroLogix™ 1500 Programmable Controller Base Units
Using Mounting Screws
Mount to panel using #8 or M4 screws.
To install your base unit using mounting screws:
1. Remove the mounting template from the inside back cover of this
document.
2. Secure the template to the mounting surface. (Make sure your base unit is
spaced properly, see "Controller Spacing" on page 9).
3. Drill holes through the template.
4. Remove the mounting template.
5. Mount the base unit.
6. Leave the protective debris strips attached until you are finished wiring the
base unit and any other devices.
Publication 1764-5.1
Mounting Template