Yakima LANDING PAD 8 Manual De Instrucciones página 2

remove trim cover plates.
If your
vehicle
has factory
crossbars,
remove
them now.
remove cover from
Landing Pad.
ATTAChmENT hArDwArE CAN LoosEN ovEr TImE.
ChECk AND TIghTEN If NECEssAry, bEforE EACh UsE.
Be sure all hardware is secured according to instructions.
Failure to perform safety checks before driving away can
result in property damage, personal injury, or death.
Continue with SkyLine or Control Tower installation.
1033092A-2/6
LUbrICATE
ThE boLTs.
Apply a water-insoluble
lubricant to bolts.
rEAD ThEsE wArNINgs!
Prepare holes for installation by pre-
installing screws. Install and remove
Use the 2 holes closest to the
Align base with
2 rear holes.
Make sure
base is parallel
to track.
remove your yAkImA rack and accessories
before entering automatic car washes.
until holes are free of debris.
rear of the vehicle.
hold Landing Pad firmly
against rail while tightening.
TIghTEN ComPLETELy.
• Consult your local dealer or fit list to see
load limitations for accessories.
• Do not exceed your factory rack limitation.