Yakima FatCat 4 Manual De Instrucciones página 5

ReMOve lIFT BOlT
• Loosen with hex wrench.
• You may need to reposition the mounts
to accommodate Ski Lift.
FatCat 6
Optional
Storage for
hex Wrench:
(inside carrier)
INSTAll SKS lOCKS ACCORdING TO
lOCK INSTRUCTIONS
(purchased separately).
WARNING: BE SURE ALL HARDWARE IS SECURED ACCORDING TO INSTRUCTIONS. ATTACHMENT
HARDWARE CAN LOOSEN OVER TIME. CHECK BEFORE EACH USE, AND TIGHTEN IF NECESSARY.
MAINTENANCE: Use non-water soluble lubricant on screws. Use
a soft cloth with water and mild detergent to clean plastic parts.
REMOVE RACKS AND CARRIERS BEFORE
ENTERING AN AUTOMATIC CAR WASH.
TECHNICAL ASSISTANCE
OR REPLACEMENT PARTS
Contact your dealer or call
(888)925-4621
Monday through Friday,
7:00 AM to 5:00 PM, PST
K e e P
1033383C - 5/15
FatCat 4
ClOSe
CARRIeRS
WITh FIRM
PReSSURe
IF YOU REMOVE YOUR CARRIER, FOLLOW INSTRUCTIONS TO REINSTALL.
Follow safety checks in accessory instructions before every installation.
To obtain a copy of this warranty, go online to www.yakima.com
T h e S e
ROTATe
lIFT dOWN
TOWARd
MOUNTING
BRACKeT
veRIFy
The
ClOSURe!
This product is covered by YAKIMA's
"Love It Till You Leave It" Limited Lifetime Warranty
or email us at yakwarranty@yakima.com
or call (888) 925-4621
I N S T R U C T I O N S !
ATTACh lIFT
TO MOUNTING
BRACKeT
• Use lift bolt
(Step 0).
• Tighten lift bolt
completely.
• Re-tighten the
front base screw.
• Verify closure of carrier by
pulling upward on skis.
ReAR hATCh
ALWAYS USE CAUTION
WHEN OPENING
YOUR HATCH.
To extend the life of your
product, clean and remove the
carrier at the end of the season