RIEJU MRT 50 Manual Del Propietário página 111

manual usuari mtr ang ok.qxp 12/06/2012 10:07 Página 29
4. Once the dirt has been removed, wash all the surfaces with warm water and soft detergent. To get to
the difficult areas, use a bottle-washing brush or something similar.
5. Immediately rinse with cold water and dry all the surfaces.
6. Clean the seat with a combination vinyl upholstery cleaner to keep it lustre and flexible.
7. To finish off, start the motor and let it run slowly for a few minutes. This way we can dry the bike out
completely
8. When dry inspect the bike for any corrosion, it way be necessary to repaint the exhaust with a heat
protective paint and touch up stone chips on the frame to prevent further corrosion.
LUBRICATION
Apply lubrication to all cables, Chain and sprockets if necessary. Plus a water repellent agent to all elec-
trical switches and exposed connections.
STORAGE.
Storage of the motorcycle for a long period of time demands certain care to prevent deterioration. Once
it is clean and lubricated, prepare to store the motorcycle in the following manner:
1. Drain the petrol tank, petrol pipes and the carburettor bowl.
2. Take the spark plug out and put a spoonful of SAE 10/30 oil through the plug hole and replace the
spark plug.
3. Cover the exhaust with a plastic bag to stop the humidity getting in.
4. Completely cover a bike with a sheet to keep of dust
29