Rothenberger COLLINS CLASSIC 22A 5.7070 Instrucciones De Uso página 28

4.4 The thread- oil
For use ROTHENBERGER high-performance thread- oil art. no. 6.5010.
This oil is not suitable for drinking water pipes!
Alternatively, you can use ROTHENBERGER high-performance thread- fluid,
art. no. 6.5015. This fluid is suitable for all pipelines including drinking water pipelines.
Keep thread- oils out of the reach of children!
Do not thin thread- oil or mix it with other oils! If the thread- oil becomes mixed with
water, it turns milky-white, its quality is reduced and the tapped thread displays lower
quality. It is then recommended to change the oil!
Avoid direct sunlight and store the oil in a dark place!
Close the oil container tight after use in order to prevent the ingress of dirt and water!
ATTENTION PERSONS WITH ALLERGIES!
Thread- oil that lands on the skin can cause skin irritation, inflammation and allergic
reactions! When handling oil, wear protective clothing and cover exposed skin areas. If
your skin comes into contact with oil, wash it immediately with tap water and soap. If
thread- oil burns onto hot workpiece or tool surfaces, this can produce toxic vapours or
gases (e.g. chlorine gas when red oil burns). If you have accidentally inhaled this oil
mist or oil vapours, go out into the fresh air immediately and consult a doctor without
delay!
4.5 Checking the thread- oil
A new machine or a machine that has not been used for an extended period is covered
with an oil film to protect it. Remove this with a clean cloth.
On the right side of the machine, fill up with the supplied thread- oil (3-4l).
Ensure that the machine is still switched off and insert the mains plug back into the
socket.
Switch on the machine and ensure that the thread- oil runs out of the thread- head to the
cutting jaws. If the right amount of oil is not supplied, regulate it with the oil adjustment
screw.
4.6 Setting the supplied thread- oil quantity
When cleaning, servicing, inspecting or repairing the machine, it is essential to
switch it off and pull out the mains plug (de-energised operation)!
Ensure that the oil tank is filled with oil.
If the amount of thread- oil running via the thread- head does
not meet the requirements, the supplied amount must be
adjusted at the oil pump (1) with the aid of the oil adjustment
screw (3). Therefore remove housing.
Undo the locking nut (2) of the oil adjustment screw.
Turning the oil adjustment screw clockwise increases the
amount of oil delivered and turning it anti-clockwise reduces
the amount.
Tighten the locking nut firmly after making the adjustment.
26
ENGLISH
1
2
3