DeWalt DW934 Manual De Instrucciones página 16

MAINTENANCE
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories.
Replacing Sight Window (Fig. 1)
The sight window must be replaced by an authorized D
service center.
WARNING: Do not operate the saw with a damaged or
missing sight or front window. If window is damaged or missing,
have the saw serviced at an authorized service center. If the saw
is operated without the window, metal chips could fly through the
guard and cause personal injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry
air at least once a week. To minimize the risk of eye injury, always
wear ANSI Z87.1 approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
CAUTION: Do not use any cleaning fluids on the sight window or
the front window to avoid clouding them and compromising the safe
operation of the saw. Use compressed air to remove accumulated
dust from the inside of the sight and front windows. Wear safety
glasses when performing this.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do
not use water or any cleaning solutions.
Lubrication
Self lubricating ball and roller bearings are used in the tool and
relubrication is not required. We recommend that you take or
send the tool to a certified service center for a thorough cleaning,
inspection, and lubrication of the gear case annually, depending on
how much you use the tool.
Repairs
WALT
E
The charger is not serviceable. There are no serviceable parts
inside the charger.
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustments (including brush inspection and replacement)
should be performed by a D
D WALT authorized service center or other qualified service
E
personnel. Always use identical replacement parts.
Accessories
WARNING: Since accessories, other than those offered by
DeWalt, have not been tested with this product, use of such
accessories with this tool could be hazardous. To reduce the risk
of injury, only DeWalt, recommended accessories should be used
with this product.
Use only 6-3/4" (171 mm) D
mm arbor.
Recommended accessories for use with your tool are available at
extra cost from your local service center. If you need any assistance
in locating any accessory, please contact D
Co., 701 East Joppa Road, Baltimore, MD 21286, call 1-800-4-
D WALT (1-800-433-9258) or visit our website www.dewalt.com.
E
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to faulty
E
materials or workmanship for three years from the date of purchase.
This warranty does not cover part failure due to normal wear or tool
15
WALT factory service center, a
E
WALT metal cutting blades with a 20
E
WALT Industrial Tool
E