Whirlpool 8MWTW2024 Manual Del Usario página 19

TROUBLESHOOTING
First try the solutions suggested here to possibly avoid a service call.
If you experience
Washer not performing as expected (cont.)
Sand, pet hair, lint, etc.
on load after washing
Load is tangling
Not cleaning or
removing stains
The washer is repeating
the rinse cycle
09-Feb-2018 07:28:55 EST | RELEASED
Possible Causes
Heavy sand, pet hair, lint,
and detergent or bleach
residues may require
additional rinsing.
Washer not loaded as
recommended.
Washer not loaded properly.
Detergent is being added
over the load
Not using enough detergent.
Not using correct cycle for
fabric type.
Using too much detergent
The load could be
unbalanced
In some European factories the letter "W" of the part code mentioned herein will be automatically
Select a Rinse/Spin cycle.
See "Using Your Washer" section.
Consult the Cycle Guide to see what best cycle for your load is.
Load garments in loose heaps evenly around the basket wall.
Reduce tangling by mixing types of load items. Use the recommended cycle
for the type of garments being washed.
Washer is less efficient at cleaning when overloaded.
Load garments in loose heaps evenly around the basket wall.
Load with dry items only.
Add only 1 or 2 garments after washer has started.
Add detergent, Oxi products and the bleach (powder presentation) at the
bottom of the basket before loading the washer.
Always measure detergent and follow detergent directions based on load size
and soil level.
Use a higher soil level cycle option and warmer wash temperature to improve
cleaning.
Use the Whites cycle for a deep cleaning.
Consult the Cycle Guide to see what best cycle for your load is.
Suds from regular detergents can slow or stop the washer. Always measure
detergent and follow detergent directions based on your load requirements.
Load the dry items on even heaps around the basket. Adding wet items or
adding extra water to the basket could cause an unbalanced condition.
Wash smaller loads.
Do not tighten the clothes in the basket. Do not wash a single item.
See the Guide Cycle and Using your washer section for more information.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
Solution
19