Whirlpool 8MWTW2024 Manual Del Usario página 7

Indicator animation
7 Start/Pause (Inicio/Pausa) button
Press this button to start the selected cycle; press the button one
more time to pause the cycle and unlock the lid during the Drain
cycle or Spinning. (see How to Cancel a cycle).
When pressing the Start/Pause button, the washer equipped with
Auto Level will start the detection routine and will continue with
the Filling stage about a minute after.
NOTE: If the washer is draining or spinning, it may take a few
minutes for the lid to unlock.
10 Indicator lights during the wash cycle
The Cycle Status Lights shows the progress of a cycle. At each
stage of the process, you may notice sounds or pauses that are
different from traditional washers.
When the START/PAUSE button is pressed, the washer will start
filling the water.
NOTE: The maximum efficiency of your washer is reached when
the lid is closed
The washer will then move the load briefly, pause to allow water
to soak in to the load, and resume adding water.
This process may repeat until the correct amount of water has
been added to the load.
09-Feb-2018 07:28:55 EST | RELEASED
Description
Auto Level
You will see this
animation during the load
size detection routine.
Filling stage
You will see this
animation while the
washer fills the basket
with water.
Recovery
You will see this
animation while the
washer performs the
Recovery routine to
remove the excess of
suds or rearrange the
load.
Paused cycle
This animation will be
displayed each time the
system is paused.
Cancelled cycle
This animation will be
displayed each time a
cycle is cancelled.
This animation will remain
until the water is drained.
In some European factories the letter "W" of the part code mentioned herein will be automatically
SOAK
The washer will start this portion of the cycle once the drum is
filled with the selected level of water. Soaking helps to remove
tough stains.
WASH
Low-water cleaning means concentrated cleaning. Rather than
diluting detergent as done in an agitator-style washer, this washer
delivers the detergent directly to the soils. The motor sounds may
change at different stages in the cycle.
RINSE
You will hear sounds similar to the wash cycle as the washer
rinses and moves the load.
DRAIN/SPIN
The washer spins the load at increasing speeds for proper water
removal.
DONE
This light will turn on once the cycle is complete. Remove the
clothes from the washer for better results.
LID
This light indicates that the lid is locked and cannot be opened.
If you need to open the lid, press START/PAUSE. The lid will
unlock once the washer movement has stopped. Close the lid.
Press START/Pause again to resume the cycle.
NOTE: This may take several minutes if the load was spinning at
high speed.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
7