Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Base
The installations and corner valves are located in the base behind the inspection cover.
Note: We recommend fitting the feed pipes with an „Aqua-Stop" unit.
If the equipment is operated without an „Aqua-Stop" the main tap must be closed after work is finished.
a. Inspection cover (fig. 3)
• To open, grasp the upper recess and pull to release magnetic connector,
then lift out of the lower seating.
WARNING: Always isolate the complete system and secure against unintended
switch-on before opening the inspection cover!
When closing the cover first align below and afterwards click back into the magnetic connector
above.
b. Care of the plastic surfaces
• Clean the plastic surface of the base with a damp cloth or a micro-fibre cloth, if necessary with
a mild household cleaning fluid.
• Under no circumstance use an abrasive cleaner!
• Please ensure that spots of various hair chemical agents (above all directly applied colouring
agents) do not fall on the plastic surfaces, as these cannot be removed.
4.
Accessories
• Seat cover (Fig. 4)
To protect the upholstery you can lay a cover over the back of the seat.
• Towel holder (Fig. 5)
As an optional extra the wash unit can be equipped with a chromed towel holder (on the left, the
right or on both sides - on each side, however, only one towel holder or one oddments tray is
possible).
• Oddments trays (Fig. 10)
As an optional extra the wash unit can be equipped with oddments trays (left, right or on both sides
- on each side, however, only one towel holder or one oddments tray is possible). Oddments trays
can be removed for cleaning: to do this unscrew the handy knurled head screw under the tray and
pull the tray upwards. For cleaning the trays see care instructions 2a.
GB
3
Publicidad
