Sherwood RD-6505 Instrucciones De Funcionamiento página 37

RD-6505(G)_100311_RD-5503(g) 2010-05-03 오후 6:45 페이지 37
When selecting the CROSSOVER
• When speakers are set to "S (Small)", be sure to set their crossover frequency correctly according to their frequency
characteristics.
1.
Press the CURSOR UP(▲)/DOWN(▼) buttons
to select the "X-OVER", then press the ENTER
button.
2.
Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to set the crossover frequency as
desired.
• You can adjust the crossover frequency within the
range of 40 ~ 200 Hz in 10 Hz intervals.
■About the crossover frequency
• When speakers are set to "S (Small)", low frequencies
in those channels that are below the crossover
frequency are to output from subwoofer or front
speakers which are set to "L (Large)" (when not using
a subwoofer).
• Refer to the operating instructions of the speakers to
be connected. If the frequency range of your speaker
is 100 Hz~20 kHz, the crossover frequency should be
set to 100 Hz(or slightly higher).
37