Sherwood RD-6505 Instrucciones De Funcionamiento página 7

RD-6505(G)_100311_RD-5503(g) 2010-05-03 오후 6:44 페이지 7
4.
CONNECTING DIGITAL INS
• The OPTICAL and the COAXIAL DIGITAL OUTs of the
components that are connected to CD and VIDEO 1~VIDEO 2
of this unit can be connected to these DIGITAL INs.
• A digital input should be connected to the components such as
a CD player, DVD player, etc. capable of outputting DTS Digital
Surround, Dolby Digital or PCM format digital signals, etc.
• For details, refer to the operating instructions of the component
connected.
• When making the COAXIAL DIGITAL connection, be sure to
use a 75Ω COAXIAL cord, not a conventional AUDIO cord.
• Some of the commercially available optical fiber cords cannot
be used for the equipment. If there is an optical fiber cord which
cannot be connected to your equipment, consult your dealer or
nearest service organization.
■Note :
• Be sure to make either a OPTICAL or a COAXIAL DIGITAL connection on each component.
(You don't need to do both.)
■Digital input default settings
• If you connect the DIGITAL INs to your components, it is easier to do so following the default settings.
• If your DIGITAL connections are different from default settings, you should assign the DIGITAL INs you used with the
"When selecting the DIGITAL IN" procedure on page 33.
• The default settings are as follows : OPTICAL IN : VIDEO 1, COAX-1 IN : VIDEO 2, COAX-2 IN : CD
5.
CONNECTING SUBWOOFER PRE OUT
• To emphasize the deep bass sounds, connect a powered
subwoofer
.
7