Replacing The Light Bulb - 3M PPS SUN GUN II Manual De Instrucciones

Replacing the Light Bulb

To replace light bulb, remove the lamp bezel by turning it counter-clockwise to release it from the lamp housing.
Grasp the edge of the bulb and depress slightly while turning counter-clockwise to release the bulb from its
socket. To install a new bulb, insert the bulb into the keyed socket and depress slightly while turning the bulb
clockwise until it is stops and is firmly seated. Reinstall the lamp bezel by aligning it to the housing and turning
clockwise until the bezel engages the hooks and snaps into place. Note: To ensure safe and proper operation, use
only 3M bulb (PN 16551) in the 3M™ PPS™ SUN GUN™ II Light.
Replacing the Diffuser
To replace the diffuser, remove the lamp bezel by turning it counter-clockwise to release it from the lamp housing.
From the front side of the bezel, push the diffuser toward the back of the bezel to snap it out of position. Place a
new diffuser in position and press it into place. Reinstall the lamp bezel by aligning it to the housing and turning
clockwise until the bezel engages the hooks and snaps into place. To ensure safe and proper operation, use only
3M Diffuser (PN 16552) in the 3M™ PPS™ Sun Gun™ II Light.
8