Makita VC1310L Manual De Instrucciones página 3

or cleaner performance will be
adversely affected. For outdoor
applications use an extension cord
suitable for outdoor use.
7. VOLTAGE
connecting the cleaner to a power
source (receptacle, outlet, etc.) be
sure the voltage supplied is the
same as that specified on the
nameplate of the cleaner. A power
source with voltage greater than that
specified for the cleaner can result
in SERIOUS INJURY to the operator
as well as damage to the cleaner. If
in doubt, DO NOT PLUG IN THE
CLEANER. Using a power source
with voltage less than the nameplate
rating is harmful to the motor.
8. AVOID UNINTENTIONAL STARTING.
Be sure switch
plugging in.
9. Do not attempt to pick up flammable
materials,
cigarettes, hot ashes, hot metal
chips, sharp materials such as
razors, needles, broken glass or the
like.
10. NEVER USE THE CLEANER IN THE
VICINITY OF GASOLINE, GAS, PAINT,
ADHESIVES OR OTHER HIGHLY
EXPLOSIVE
switch emits sparks when turned ON
and OFF. And so does the motor
commutator during operation. A
dangerous explosion may result.
11. Never vacuum
carcinogenic, combustible or other
hazardous
asbestos,
beryllium, lead, pesticides, or other
health endangering materials.
12. Never use the cleaner outdoors in
the rain.
13. Do not use close to heat sources
(stoves, etc.).
14. GUARD AGAINST
SHOCK. Prevent body contact with
grounded surfaces. For example;
pipes, radiators, ranges, refrigerator
WARNING:
is OFF when
fire works, lighted
SUBSTANCES.
up
materials such
arsenic, barium,
ELECTRIC
enclosures.
15. Do not block cooling vents. These
vents permit cooling of the motor.
Blockage
Before avoided otherwise the motor will
burn out from lack of ventilation.
16. Keep proper footing and balance at
all times.
17. DO NOT ABUSE CORD. Never carry
the cleaner by cord or yank it to
disconnect from receptacle. Keep
cord away from heat, oil, and sharp
edges.
18. Do not fold, tug or step on the hose.
19. Stop the cleaner immediately if you
notice
anything abnormal during operation.
20. DISCONNECT
When not in use, before servicing,
and when changing accessories.
21. Clean
immediately after each use to keep
it in tiptop operating condition.
22. MAINTAIN THE CLEANER WITH
CARE. Keep the cleaner clean for
better
Follow instructions for changing
accessories. Inspect cleaner cords
periodically and if damaged, have
repaired
The facility. Inspect extension cords
periodically and replace if damaged.
Keep handles dry, clean, and free
from oil and grease.
23. CHECK DAMAGED PARTS. Before
toxic, further use of the cleaner, a guard or
other part that is damaged should be
as carefully checked to determine that
it will operate properly and perform
its intended function. Check for
alignment of moving parts, binding
of moving parts, breakage of parts,
mounting, and any other conditions
that may affect its operation. A
guard or other part that is damaged
should be properly repaired or
replaced by an authorized service
center unless otherwise indicated
elsewhere in this instruction manual.
3
should be
poor performance
THE
and service the
and safer performance.
by authorized
carefully
or
CLEANER.
cleaner
service