Orbegozo PHE 75 Manual De Instrucciones página 23

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PHE 75/PHE 80
shall be shut off and the appliance shall be investigated
and rectified before it is used again;
To check the hose at least once per month,each time the
cylinder is changed,or each time before long time no use.
If it shows signs of cracking, splitting or other deterioration
it shall be exchanged for new hose of the same length and
of the
equivalent quality;
The use of this appliance in enclosed areas can be
dangerous and is PROHIBITED;
Read the instructions before using this appliance. The
appliance must be installed in accordance with the
instructions and
local regulations.
HEATER STAND AND LOCATION
The heater is primarily for outdoor use only. Always ensure that adequate fresh
air ventilation is provided.
Always maintain proper clearance to non protected combustible materials i.e.
top 100 cm and sides 100 cm minimum.
Heater must be placed on level firm ground.
Never operate heater in an explosive atmosphere like in areas where gasoline
or other flammable liquids or vapors are stored.
To protect heater from strong wind, anchor the base securely to the ground
with screws.
GAS REQUIREMENTS
Use propane, butane or their mixtures gas only.
The pressure regulator and hose assembly to be used must conform to local standard codes.
The installation must conform to local codes, or in the absence of local codes, with the standard for the
storage and handling of liquid petroleum gases.
A dented, rusted or damaged tank may be hazardous and should be checked by your tank supplier. Never
use a tank with a damaged valve connection.
The tank must be arranged to provide for vapor withdrawal from the operating cylinder.
Never connect an unregulated tank to the heater.
23

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Phe 80

Tabla de contenido