Door Reversibility - Zanussi ZFU625MW Manual De Instrucciones

The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted as shown in the figure.
Slacken the screws and insert the spacer under the
screw head, then retighten the screws.
1. Remove the plinth.
2. Unscrew and remove the
lower hinges.
3. Remove the door.
7. Unscrew the pin (A) and
screw it on the opposite
side.
8. Remove the cap (B) and
position it on the opposite
side.
9. Screw the lower hinges.
10. Refit the plinth.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket.

Door reversibility

Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during
the operations.
To change the opening direction of the door, do these
steps:
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that the compres-
sor cannot touch the floor.
4. Unscrew the upper pin
and screw it on the oppo-
site side.
5. Refit the door.
6. Make sure the edge of
the door is parallel with the
edge of the top.
11. Stand the appliance up-
right.
A
12. Fit the handle on the op-
posite side and put the plas-
tic caps (contained in the in-
structions bag) in the free
B
holes.
In case you do not want to carry out the above men-
tioned operations, contact the nearest After Sales Serv-
ice Force. The After Sales Service specialist will carry
out the reversibility of the doors at your cost.
9