Maintenance And Inspection - Metabo HPT FCJ 65V3 Instrucciones De Manejo

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
Material to be cut
Lumber
Iron plate
Nonferrous metal
Synthetic resin
Pulp
Others
2. Acceptable commercial blades (Fig. 14)
This machine is designed to accept most blades
available on the open market. As illustrated in Fig. 14,
blade dimension restrictions are as follows:
L2....... Less than 1.6 mm
○ Thickness :
L3....... 6.3 mm
○ Width
:
L4....... 8 mm
L5....... 7 mm
NOTE
When cutting thick materials, use metabo HPT genuine
blades which have an inclination as shown in Fig. 4-A or
B.

MAINTENANCE AND INSPECTION

1. Inspecting the blade
Continued use of a dull or damaged blade will result in
reduced cutting effi ciency and may cause overloading of
the motor. Replace the blade with a new one as soon as
excessive abrasion is noted.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power
tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
4. Replacing supply cord
If the supply cord of Tool is damaged, the Tool must be
returned to metabo HPT Authorized Service Center for
the cord to be replaced.
5. Servicing
Consult an authorized Service Agent in the event of
power tool failure.
6. Service parts list
A: Item No.
B: Code No.
C: No. Used
D: Remarks
7
Table 1 List of Appropriate Blades
Material quality
General lumber
Plywood
Mild steel plate
Aluminum, copper, brass
Phenol resin, melamine resin, etc.
Vinyl chloride, acryl resin, etc.
Foamed styrol, etc.
Cardboard, corrugated paper
Hardboard
Fiberboard
Hard rubber
Slate
CAUTION
Repair, modifi cation and inspection of metabo HPT
Power Tools must be carried out by a metabo HPT
Authorized Service Center.
This Parts List will be helpful if presented with the tool
to the metabo HPT Authorized Service Center when
requesting repair or other maintenance.
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
MODIFICATION
metabo HPT Power Tools are constantly being improved
and modifi ed to incorporate the latest technological
advancements.
Accordingly, some parts (i.e. code numbers and/or
design) may be changed without prior notice.
NOTE
Due to metabo HPT's continuing program of research
and development, the specifi cations herein are subject to
change without prior notice.
Blade No.
No. 1 or No. 31 (thick plate) or No. 41
(thick plate) or No. 2 (thin plate)
No. 3 or No. 6
No. 6
No. 6
No. 4 (thick plate) or No. 6 (thin plate)
No. 2 or No. 4 (thick plate) or No. 6
(thin plate)
No. 2
No. 2
No. 5 or No. 6
No. 6
No. 2
No. 5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Fcj 65s3

Tabla de contenido