Adjusting The Recording Interval; Erasing The Stored Data; Configuring The Leq And The Integration Time - Chauvin Arnoux C.A 1310 Manual De Instrucciones

4.4. ADJUSTING THE RECORDING INTERVAL

(1) Press the
The "Int" symbol then appears and the seconds display blinks.
(2) Set the desired recording interval, displayed in minutes and seconds. Increase or decrease
the interval by pressing the  or  key; the maximum interval is 1 minute and the minimum
is "00:01" (1 second). Press the
progress, press the

4.5. ERASING THE STORED DATA

Remark:
The battery indicator "
battery life. The number of black bars decreases
as the batteries are depleted. When the batteries
are almost fully discharged, the "
disappears. Press the
the "Lo bat" warning. If the instrument is recording,
it stops.

4.6. CONFIGURING THE LEQ AND THE INTEGRATION TIME

4.6.1. SETTING THE INTEGRATION TIME
(1) Press the
(2) Press the  or  key to increase or decrease the duration.
The selection loop-scrolls through the following values: 10s → 1mn → 5mn → 10mn → 20mn
→ 30mn → 1h → 2h → 4h → 8h → 16h → 24h.
(3) Then press the
key to enter the settings mode, then the  or  key to select the interval.
key to cancel.
To empty the memory, switch the instrument off, then press
and hold it down, then press
5 seconds. The "CLr" symbol is then displayed to indicate that the
data have been erased.
" displays the remaining
" symbol
key. The screen displays
key.
key to terminate.
key to confirm. If you want to abort the setting in
26
and keep it pressed for at least