Installing The Stability Brackets; Location Requirements - Franklin Chef FIM200 Manual Del Usuario

Installing the stability brackets

This operation requires at least two persons.
If you wish to install the ice maker in a free-standing mode rather than enclosed, it is necessary
to attach the two metallic stability brackets that can be found packed inside the ice storage bin.
Keeping the machine tilted to the right, but not more than 45 , attach one bracket to the center of
the underside of the ice maker with two screws (supplied). See illustration below. Set the unit
back on its four feet, then tilt it forward in order to screw in the second bracket on the underside
of the unit opposite the first bracket. Level the ice maker. This operation will stabilize it for
free-standing operation.

Location Requirements

This ice maker should be installed by qualified personnel.
NOTICE:
1. Before setting the ice maker inside a cabinet, connect the water supply pipe correctly.
Insert the drain hose into the drain, and connect the power supply line.
2. Do not kink or pinch the power supply line between the ice maker and wall or cabinet.
Installation clearance
Top view Side view
8