Taurus PULSAR ECO TURBO Manual De Instrucciones página 12

- Clean the appliance.
CARRY HANDLE/S:
- The device has a handle on the upper part so it
can be transported easily and comfortably.(H)
PARKING POSITION:
- This appliance has one parking position for
comfortable and straightforward storage.
- To use the horizontal parking position, fix the
break pad hook to the hook situated on the rear
side of the appliance (Fig. 3).
CLEANING
- Disconnect the appliance from the mains and let
it cool before undertaking any cleaning task.
- Clean the appliance using a damp cloth with a
few drops of detergent and then dry it.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not submerge the appliance in water or any
other liquid, or place it under a running tap.
EMPTYING THE DUST BOX:
- Empty the vacuum deposit when dust is visible
though the transparent walls, when it is full, or
when the vacuum cleaner does not work to its
full potential. Disconnect the dust box from the
appliance. (Fig. 4)
- Open the lid of the dust box and empty the
contents into the appropriate waste disposal
receptacle. (K)
- Close the lid of the dust box. (Fig. 5)
- Attach the dust box to the appliance. (Fig. 6)
- Connect the hose to the vacuum cleaner's air
intake. (Fig 1)
CHANGING THE FILTERS:
- Motor filter, it is advisable to periodically check
the state of the filter, which should be cleaned/
replaced after every 50 hours of use.
- HEPA type air outlet filter (high efficiency air fil-
ter which effectively removes spores, ash, dust
mites, pollen ...), it is advisable to periodically
check the condition of the filter, it should be
cleaned/replaced after every 50 hours of use, or
if a significant drop in suction power is noticed.
- To remove filters:
MOTOR FILTER:
Disconnect the dust box from the appliance (Fig.
4)
- Open the cover (R) that contains the filter (Fig.7)
- Remove the filter (Q) from its housing. (Fig. 8)
- To reassemble the filter, proceed with the above
instructions, in reverse order.
OUTLET FILTER:
- Open the air outlet grate, to access the filter
(Fig. 9).
- Remove the filter (P) from its housing. (Fig. 8)
- To reassemble the filter, proceed with the above
instructions, in reverse order.
CLEANING THE MINI TURBO NOZZLE:
1) Turn and pull out of the holding clamp.
2) Open the top section and clean the inside of
the nozzle.
3) Refit the nozzle by performing the opposite
process.
SUPPLIES
- Supplies can be acquired from distributors and
authorised establishments (such as filters, etc. )
for your appliance model.
- Always use original supplies, designed specifi-
cally for your appliance model.
-These supplies are available in specialist shops.
ANOMALIES AND REPAIR
Take the appliance to an authorised technical
support service if problems arise. Do not try to
dismantle or repair without assistance, as this
may be dangerous.
FOR EU PRODUCT VERSIONS AND/OR IN
THE CASE THAT IT IS REQUESTED IN YOUR
COUNTRY:
ECOLOGY AND RECYCLABILITY OF THE
PRODUCT
- The materials of which the packaging of this
appliance consists are included in a collection,
classification and recycling system. Should you
wish to dispose of them, use the appropriate
public containers for each type of material.
- The product does not contain concentrations of
substances that could be considered harmful to
the environment.
This symbol means that in case you wish
to dispose of the product once its working