Yakima OverHaul HD Tonneau Manual De Instrucciones página 4

5
TIGHTEN THE LOCK POSTS.
Using the 4 mm hex
wrench tighten the
lock posts to 10 Nm.
6
LOCK THE TOWER.
Install the locks onto the lock posts
and use the key to lock your towers.
7
SET THE HEIGHT.
A
X
Instruction #1036027B-Page 4 of 11
A. Measure to find your desired crossbar height. This distance (X) may be to
your naked roof, or to your existing rack's crossbar.
B. Loosen tower bolts then using the scale on the tower set each tower to that
measurement (X) (measurements are in inches).
C. Fully tighten both tower bolts on each tower with the 6mm wrench to 18 Nm.
B
X
4X
10 Nm
NOTE: If a replacement
OverHaul accessory lock
(#8881014) is used, you'll
need to remove the screw
shown here with a T15
wrench to work with this kit.
C
18 Nm
4X
2X 2X